Are you looking for IN Instrumentation Engineering GATE 2016 question paper ? You can download it in PDF format below. Read more details about the download of IN Instrumentation Engineering GATE 2016 question paper here under.
Exam Board: IIT Bangalore
Exam Name: GATE-2016
Subject Name: EC Electronics and Communication Engineering
Session: 4
Source of Information: http://www.gate.iisc.ernet.in/GATE2016questions/S4_IN.pdf
Also Check:
1. GATE-2016: MA Mathematics Question Paper PDF
2. GATE-2016: PE Petroleum Engineering Question Paper PDF
3. GATE-2016: EC Electronics and Communication Engineering Question Paper PDF
Sample Questions:
Q.33 A symmetrical three-phase three-wire RYB system is connected to a balanced delta-connected load. The RMS values of the line current and line-to-line voltage are 10 A and 400 V respectively. The power in the system is measured using the two wattmeter method. The first wattmeter connected
between R-line and Y-line reads zero. The reading of the second wattmeter (connected between Bline
and Y-line) in watt is ______.
Q.34 In the strain gauge bridge circuit given below, R1 = R3 = R (1 − x) and R2 = R4 = R (1 + x), where R is 350 Ω. The voltage sources vs and vn represent the dc excitation and the undesired
noise/interference, respectively. The value of capacitor C in microfarad that is required to ensure
that the output across a and b is low-pass filtered with a cutoff frequency of 150 Hz is ________.
Download PDF file here at GATE-2016: IN Instrumentation Engineering Question Paper PDF
Exam Board: IIT Bangalore
Exam Name: GATE-2016
Subject Name: EC Electronics and Communication Engineering
Session: 4
Source of Information: http://www.gate.iisc.ernet.in/GATE2016questions/S4_IN.pdf
Also Check:
1. GATE-2016: MA Mathematics Question Paper PDF
2. GATE-2016: PE Petroleum Engineering Question Paper PDF
3. GATE-2016: EC Electronics and Communication Engineering Question Paper PDF
Sample Questions:
Q.33 A symmetrical three-phase three-wire RYB system is connected to a balanced delta-connected load. The RMS values of the line current and line-to-line voltage are 10 A and 400 V respectively. The power in the system is measured using the two wattmeter method. The first wattmeter connected
between R-line and Y-line reads zero. The reading of the second wattmeter (connected between Bline
and Y-line) in watt is ______.
Q.34 In the strain gauge bridge circuit given below, R1 = R3 = R (1 − x) and R2 = R4 = R (1 + x), where R is 350 Ω. The voltage sources vs and vn represent the dc excitation and the undesired
noise/interference, respectively. The value of capacitor C in microfarad that is required to ensure
that the output across a and b is low-pass filtered with a cutoff frequency of 150 Hz is ________.
Download PDF file here at GATE-2016: IN Instrumentation Engineering Question Paper PDF
0 comments:
Pen down your valuable important comments below