Anna University Chennai
B.E./ B.Tech. DEGREE EXAMINATION Nov Dec 2016
06th Semester / III Year
Instrumentation and Control Engineering
IC6601 Advanced Control System
(Regulation 2013)
Nov Dec 2016 Important Questions
Important 16 Marks Questions (All five units) are listed for IC6601 Advanced Control System subject.
1. What is state? Write about concept of state variable
2. Derive the expression for the calculation of the transfer function from the state variables for the analysis of system?
3. Describe the isoclines method of drawing Phase plane trajectory.
4. Write short notes on canonical form of representation. List its advantages and disadvantages?
5. Discuss about Phase Plane
B.E./ B.Tech. DEGREE EXAMINATION Nov Dec 2016
06th Semester / III Year
Instrumentation and Control Engineering
IC6601 Advanced Control System
(Regulation 2013)
Nov Dec 2016 Important Questions
Important 16 Marks Questions (All five units) are listed for IC6601 Advanced Control System subject.
1. What is state? Write about concept of state variable
2. Derive the expression for the calculation of the transfer function from the state variables for the analysis of system?
3. Describe the isoclines method of drawing Phase plane trajectory.
4. Write short notes on canonical form of representation. List its advantages and disadvantages?
5. Discuss about Phase Plane
6. Discuss about describing function. Give its limitations
7. Derive the describing function of saturation non-linearity.
8. Derive the describing function of dead zone of non-linearity
9. Derive the describing function of relay with deadzone.
10. Explain the concept of formulation of the optimal control problem.
11. Explain about minimum time problem.
12. Explain about minimum energy control.
13. Explain about minimum fuel problem?
14. Explain about state regulator problem?
15. Explain about tracking problem?
16. Explain about continuous time regulator problem?
17. Explain about discrete time regulator problem?
18. Describe the delta method of drawing Phase plane trajectory
19. Discuss the characteristics of non-linear system
20. Describe limit cycles in phase portrait
0 comments:
Pen down your valuable important comments below